Installation in the door frame

[zihadhosenjm40]

Next, the holes need to be transferred to the long planks. To do this, join them, align the edges. Using a drill, transfer the marks to the end of the plank, then deepen to the required length (along the length of the screw). Having made the holes, join the planks, screw in the fasteners. The extension to the interior door is half assembled. But do not rush to attach the second plank. You need to try on what has already been assembled "on site".

Fitting and trimming

We put the assembled L-shaped part in place, driving the strips bahamas mobile database the groove in the door frame. The upper crossbar turned out to be larger (we measured it like this). We take a pencil, put a mark where the groove begins. Try to be precise, as this is important. You don’t have to cut off the excess. Just draw a line along the mark and make marks on it, then drill holes. After assembly, we get the letter “P”. We have assembled the extension for the interior door, now we need to install it and secure it.

Now the extension can be installed. Check the opening beforehand. If the doors were installed on foam, it may block the groove. Cut off the excess so that the strips go in freely. Insert the U-shaped structure into the groove, tapping the end with your palm. Start from the top, then from the sides.

We put it in place, having previously removed the excess mounting foam

We take masking tape and fix the strips to the walls. If in some places the extension to the interior door does not fit tightly to the frame (there is a gap), we close this gap using linings. For this, you can use mounting wedges. If you don’t have them, make them from foam plastic. You just need to set the strip evenly; dense foam plastic is enough for this purpose.

Fastening of the extension box
You also need to align the extension on the interior door to the level. You shouldn't rely on your eyes, use a level. Using a level and wedges, remove all protrusions and blockages. In the process, fix the aligned sections with masking tape. The distance between the tacks is 40-50 cm. One at the top and one at the bottom (approximately 10 cm away), and then at equal intervals.