These problems can be considered a

[zihadhosenjm40]

Hammered nails

"trifle", but what to do if the wall and the door frame have a fairly large discrepancy? There are two ways to solve the problem, both of them are unpleasant and take a lot of time and nerves.

The door frame is too recessed into the wall. You will have to chisel the wall - the work is dusty, noisy and dirty. Put the casing against the frame and draw a line on the wall. Use a grinder with a diamond disk or a saw (depending on the material the wall is made of) to cut a line along the wall. Then you need to choose a niche for the casing. This can be done with a grinder, chisel, etc. Constantly check the depth of the groove. If the niche is too deep denmark mobile database some places, fill the recess with gypsum or cement mortar and immediately put the casing in the desired depth position for a few seconds, this will help you make the niche more accurately. You need to go around the entire door along the perimeter in this way.
If your casing is made of natural wood and has a decent thickness, then you can remove a little of its back side with a plane. Work very carefully, do not rush, it will be impossible to correct the mistake.
Video – How to attach door trim without nails


Video – Installing door trim on interior doors with your own hands


Little tricks
When choosing wooden door trim, pay attention to the quality of the board drying. Poorly dried wood:

has an uneven color;
has blue spots on the surface;
makes a dull sound when tapped.