The length of the cladding is measured for each fragment separately;

[zihadhosenjm40]

The first thing you need to do is prepare the casings themselves. The top edge should be beveled at an angle of 45 degrees. In addition, you must measure the length of the casing correctly. To do this, you need to know a few rules:

the first piece is measured from the side that opens towards you;
To measure the length of the casing, you need to measure the gap from the floor to the edge of the joint;
mark this on the trim strip and add another 1 cm;
This point will be the edge of the corner, but not the vertex.
After preparing the two vertical pieces, you can start attaching them. We will analyze the fastening of the trims with nails. You need to nail the side panels, but do not hammer the nails all the way in. This is necessary to correctly mark the top of the trims. To do this, you will have to slide a plastic product under the vertical trims and apply markings. Add 1 cm to this marking.

This is important! Remember that the top section of ecuador mobile database casing is joined to the vertical planks along its bottom edge, so try not to make a mistake when forming the corners. If the markings are done correctly and the cutting is precise, the top part will fit exactly in the place allotted to it.

When the three parts of the casing are ready, you can proceed to the final fastening. To fix the upper casing, you will need two nails, and for the side panels, you need to prepare 5-6.

If the fastening of the casings is done with screws, then holes must be prepared for them with a 6 or 8 mm drill so that the screw head is hidden. After that, the screws are screwed in and covered with decorative caps.

If the wall surface is perfectly flat, you can also use the method of fastening the trims with liquid nails. The cracks and spaces that are formed after joining the trims are sealed with mounting foam.