Instead of a branch you can use:

[zihadhosenjm40]

several holes are drilled in the bottom of a large container to drain condensation and rainwater carried in by the wind;
two holes are pierced in the cap of a 5-liter bottle and a wire or cord is passed through them for hanging;
To prevent the feeder from swinging in the wind, a weight is hung from the bottom of the fishing line or tied to a lower branch.
If the location of the feeder is protected from the wind, instead of a "room" made from a 5-liter bottle, it is enough to use a canopy made from the top of a 20-liter bottle. The feeder is attached to it from below by the "petals" by gluing with "liquid nails" or mechanically (bolts or screws).

Perch
A long branch as thick as a pencil is pierced through the feeder. The spain mobile database protruding on both sides will become perches, providing a comfortable landing for the birds.

The holes for the perch are cut at a distance of 40 mm from the bottom of the feeder. Their diameter should ensure a tight fit of the rod. Otherwise, the feed will spill through them.


simple pencils;
sturdy chopsticks;
wire, etc.
To increase the number of "seating" places, additional perches are installed. They are located 50-70 mm higher than the main ones and at an angle to the latter.

For reliability, the rods are fixed with glue. At the same time, it will act as a sealant, preventing water from seeping through the gaps.

Which food is better?
Different types of feed are characterized as follows: